RCD Breakout [Full Kit] |
Build your own Rotating Clock Divider Breakout, with the RCDBO kit.
The Do-it-yourself kit includes all the parts necessary to build a fully-featured RCD Breakout. This is a beginner-level kit, you need only minimal prior experience, but you must have some basic hand tools (flush snips, needle-nose pliers, and a wire stripper).
Basic Features:
- Gate Counting: Down/Up
- Gate/Trigger mode
- Divide range up to Divide-by-64
- Spread mode: Spread mode causes the output to "spread" evenly amongst the entire max division range (see manual).
- Auto-reset: 16/off
Electrical and Mechanical Specifications:
- Module Size:
- 4HP Eurorack fromat module
- 1.85" (48mm) deep
- Power consumption:
- +12V rail: __mA
- +5V rail: not used
- -12V rail: not used
User Manuals:
- Wiring guide
- Kit parts
- User Manual Version 1.1 (updated 2012 April 24)
- RCD Breakout connection guide
- How to Update your own RCD by yourself: Download the hex file below. Then follow these instructions: Updating Firmware on AVR chips
- Version 1.1 (2012 April 24) for PCB 1.0.2, 1.0.3, and 1.0.4: hex file (adds Spread mode)
- Old Version 1.0.2 for PCB 1.0.1 and up: hex file
- Old Version 1.0.2 for PCB 1.0: hex file
- 4ms RCD github: Always the latest version, as well as other clocker verisons (Tracking Gate Sequencer, DinSync SCM, etc...): 4ms github